The output signal that is used to trigger magnetos differs from a conventional electronic ignition system. The Tach convertor is a compact device that converts the Pro-Mag's coil signal into a 12 volt square wave signal, so common tachometers designed for electronic ignitions can be used with the Pro-Mag. The convertor is less than three inches in length and its circuits are encased in epoxy for water and vibration resistance.

More From This Category

MSD Spark Plug Wire Components, Hemi Tubes, Plug Boot Type, Eight Straight Hemi Boot Ends, Rynite Plastic, Black, 8.5mm, Set of 8

MSD Spark Plug Wire Components, Hemi Tubes, Plug Boot Type, Eight Straight Hemi Boot Ends, Rynite Plastic, Black, 8.5mm, Set of 8

$256.33

MSD Short Pro Mag 12 Lite Magneto

MSD Short Pro Mag 12 Lite Magneto

$3,850.20

MSD Extension Harness, Pro Mag 44, 24 in. Length, Each

MSD Extension Harness, Pro Mag 44, 24 in. Length, Each

$262.15

MSD Distributor Rotor, Pro Mag 44, Use w/Standard Cap, Each

MSD Distributor Rotor, Pro Mag 44, Use w/Standard Cap, Each

$75.84

MSD Ignition Mounting Plate

MSD Ignition Mounting Plate

$179.21

MSD Switch, Crank Trigger/Generator Cross-Over, Toggle, Three Pre-Wired Harnesses, Each

MSD Switch, Crank Trigger/Generator Cross-Over, Toggle, Three Pre-Wired Harnesses, Each

$388.42