Must be used with CAN-Bus Hub, PN 7740 to complete circuit. Without the CAN-Bus Terminator in place at the end of the CAN-Bus system, signals could be distorted. These distorted signals could result in permanent or intermittent problems that include but are not limited to; improper timing, false signals, and repetitious signals. Always be sure to have the MSD Controller and the CAN-Bus Terminator at the ends of the MSD CAN-Bus.

Features:
  • For use with Power Grid Controller
  • 4-Connector CAN-Bus Hub required
  • More From This Category

    MSD Replacement, Exhaust Back Pressure Sensor, Harness Included, Power Grid, 0-75 PSI, Each

    MSD Replacement, Exhaust Back Pressure Sensor, Harness Included, Power Grid, 0-75 PSI, Each

    $181.93

    MSD Replacement Harness, Pressure Sensor #1, Power Grid, Each

    MSD Replacement Harness, Pressure Sensor #1, Power Grid, Each

    $65.32

    MSD Harness Adapter, 7730 to Digital-7 Prog

    MSD Harness Adapter, 7730 to Digital-7 Prog

    $485.54

    MSD Oxygen Sensor Module, Power Grid Wide Band, 0-5 V, Bosch 4.9 Oxygen Sensor, Kit

    MSD Oxygen Sensor Module, Power Grid Wide Band, 0-5 V, Bosch 4.9 Oxygen Sensor, Kit

    $697.11