Holley EFI Cam Sync Signal is designed to generate a cam sync input signal to the ECU when used in flying magnet cam trigger setups. This sensor is a Hall Effect sensor, meaning it outputs a square wave signal, which is ideal for use with most electronic fuel injection systems.

Features:
  • 3 wire hall-effect camshaft sensor, generates digital square-wave signal
  • For use with flying magnet targets only – South pole of magnet facing sensor
  • Can operate from 8-20 volts; mating connector included
  • M12x1 threads for finer gap adjustability; Approx. 1.5” length
  • More From This Category

    Haltech Inputs and CAN Expansion Products, Air Temp Sensors, Weld Fitting - Aluminum Thread: 3/8 NPT 18TPI, Each

    Haltech Inputs and CAN Expansion Products, Air Temp Sensors, Weld Fitting - Aluminum Thread: 3/8 NPT 18TPI, Each

    $15.00

    Racepak Sensors, Thermocouple Head Temp

    Racepak Sensors, Thermocouple Head Temp

    $352.87

    Haltech Inputs and CAN Expansion, Map Sensors, 250 PSI Motorsport Fuel/Oil/Wastegate Pressure Sensor (Stainless Steel Diaphragm) Thread: 1/8 NPT, Kit

    Haltech Inputs and CAN Expansion, Map Sensors, 250 PSI Motorsport Fuel/Oil/Wastegate Pressure Sensor (Stainless Steel Diaphragm) Thread: 1/8 NPT, Kit

    $289.00

    Racepak Accessories, Sensor Wheelie Bar Load Cell

    Racepak Accessories, Sensor Wheelie Bar Load Cell

    $815.77

    Racepak Accessories, Gps Antenna Sma 5M

    Racepak Accessories, Gps Antenna Sma 5M

    $174.74

    Haltech Outputs and Ignition Systems, Boost Control, Boost Control Solenoid 3 Port 33Hz Thread: 1/8 NPT, Kit

    Haltech Outputs and Ignition Systems, Boost Control, Boost Control Solenoid 3 Port 33Hz Thread: 1/8 NPT, Kit

    $179.00