THE AEM WATER/METHANOL INJECTION SYSTEM ADVANTAGE
Water/methanol injection for forced induction (turbocharged or supercharged) gas-powered race engines is a proven means for effectively reducing engine inlet air temperatures and suppressing harmful detonation. This allows racers to reliably increase boost and advance ignition timing-without using high-octane racing fuel-for power gains of up to 20%. AEM's Water Injection Kits utilize robust hardware and deliver more advanced features than any other comparably priced water/methanol injection system.

Water/Methanol for All Boost Levels of Forced Induction Gas Race Engines
AEM offers two different water/methanol controller designs for gas vehicles:

One is boost dependent for forced induction vehicles up to 35 PSI of boost (kit PN 30-3300). The Boost Dependent controller has an on-board manifold absolute pressure (MAP) sensor with a molded-in nipple for a boost hose pickup.

The second controller (Kit PN 30-3350) features a multiple input design that enables users to install AEM's Water/Methanol Injection Kit on ultra-high boost vehicles (above 35 PSI) using a 0-5v voltage-based external MAP sensor.

Note: FOR OPTIMUM RESULTS, ALL WATER/METHANOL INJECTION SYSTEMS AND FLOW GAUGES SHOULD BE RUN WITH AN WMI INLINE FILTER (PN 30-3003). For additional insurance against unintended flow, particularly when the pump and tank must be installed higher than the injections nozzle, we recommend adding our optional High-Flow Low-Current WMI Solenoid (PN 30-3326).

Features:
Terminated harness features positive lock connector with integrated pump ground circuit and additional wire for optional on/off flow solenoidIncludes “Boost Safe” readiness failsafe systemOne machined billet injector with integral check valve to prevent unintended flowRecirculation-style pump with integral fittings for quiet operationLED dash light for system status and low fluid warning20 ft. of high-pressure Nylon injection tubing

More From This Category

Snow Performance Water Injection Reservoir, Plastic, 3 Quart, Each

Snow Performance Water Injection Reservoir, Plastic, 3 Quart, Each

$91.80

View
Nitrous Express Direct Port Water Methanol, 6 Cylinder Stage 3

Nitrous Express Direct Port Water Methanol, 6 Cylinder Stage 3

$2,649.35

View
Snow Performance Stage 2.5 Boost Cooler Forced Induction Progressive Water-Methanol Injection Kit W/ 2.5 Gallon Tank.  (Red High Temp Nylon Tubing, Qu

Snow Performance Stage 2.5 Boost Cooler Forced Induction Progressive Water-Methanol Injection Kit W/ 2.5 Gallon Tank. (Red High Temp Nylon Tubing, Qu

$1,109.03

View
Snow Performance Stage 4 Boost Cooler Platinum Tuning Water-Methanol Injection Kit

Snow Performance Stage 4 Boost Cooler Platinum Tuning Water-Methanol Injection Kit

$1,454.88

View
Snow Performance WM/Nozzle 14GPH

Snow Performance WM/Nozzle 14GPH

$49.33

View